- Description
KO No.1 Vacuum OCA Lamination machine + LCD Touch Screen Refurbish Machine/Tools
Suitable for capacitive touch screen Cover plate (Cover Lens) and functional Glass Sensor (Glass) of OCA laminating process; Apply to the Touch screen (Touch Panel) and liquid crystal module (LCD Panel) of the OCA laminating process, at the same time can also be applied to other areas of membrane, glass to glass (glass) of hard in hard OCA laminating process.
Parameters:
Operating:
I. Screen-Pressing Process(Mode 1:No Need Remove Bubble)
1. Check whether the connected power;
2. Switch on the power and press the button to boot the machine to check that whether the machine can operate normally or not.
3. Put the LCD with the OCA glue on the cut silicone (please stagger the silicone away from the IC position of the flat cable)
4. Open the gate and put the tray on the cabinet
5. Close the cabinet gate
6. Switch to the "mode 1" in the control system
7. Press button to boot the machine
8. Wait patiently for 2 to 6 minutes
9. Wait until the two indicator lights off or the vacuum table turns to the minimal value. Open the cabinet gate and take out the product
10. The process completed, check whether the product is normal or not.
II. Screen-Pressing Process(Mode 2:In addition to the bubble machine usee)
1. Repeat the above steps 1-5
2. Switch to the "mode 2" in the control system
3. Press button to boot the machine
4. Wait 40 seconds
5. Wait until the two indicator lights off or the vacuum table turns to the minimal value. Open the cabinet gate and take out the product
6. In addition to the bubble machine by pressing the "open" button
7. Wait for the pressure display table is displayed as zero and the "open" indicator light;
8. Open the door in addition to the bubble machine, the product put to
9. Close and fasten the handle in addition to the bubble machine, release the "open" button
10. Patiently waiting for 4-10 minutes, then repeat steps 6-9 above, the product is taken out
Package will be included :